LIGHT TRACER - ARTY - PRO A4 (I.C)

A lighted board used by placing the manga paper on top and shining the light under the paper when drawing manga or tracing.

Available in two sizes:
* A4 Size ($124.90)
* B4 Size ($148.90)

* How to remove and change the lamp *

If the lamp inside your lightbox stops working, you can easily replace it with the following instructions.
Please purchase a 10W fluorescent lamp from a store, and follow those steps:


1. Gently place the lightbox upside down, on a stable surface.
It's best to place it over something soft like a cloth or a towel, so that the top doesn't get scratched while you change the lamp.

2. Remove the screws as shown in the image.

3. Lift the top part of the lightbox and separate it from the base.

4. Gently rotate the lamp as indicated in the image, in order to align the prongs on each side of the lamp with the spot allowing the lamp to be pulled out.
■ How to pull the fluorescent lamp out.
Gently rotate it 45 degrees and then pull it out.

5. To insert a new fluorescent lamp, reverse the instructions of step 4, sliding the lamp in and then rotating it to secure it in place.
■ How to insert a new fluorescent lamp.
Slide it in and then gently rotate it 45 degrees to secure it.

6. Put the top on the base again, fasten the screws back in place, and you're done!

(Warning: Please note that Japanese & American voltage may differ)

(*In the case of defective or faulty products, Akadot Retail will not be held responsible or liable to replace the defective products nor refund. Customers will need to contact the manufacturer themselves.)